7/24/2023 0 Comments Apple airport wifi![]() (Note by doing this over ethernet it is often more reliable than using wifi. Click on the new device that needs configuration. It will appear as (1) in Other Wi-Fi Devices. Plug the new or reset router WAN port by short patch ethernet cable to the Main router. simply plug the two together and run through the setup wizard.ฤก. (Note: the computer I'm running the airport utility on is running Mojave with the latest update as of today. Do I need to add a second master and a second switch?) Is this possible to do? If so, how do I set the configurations for this? If not, then can I just use an additional couple expresses to create a second network which I then call the guest network? (In that case, how would I configure those expresses, given that they're not actually extending the "master"'s network. Ideally I'd like to use this setup to create both a main and a separate guest network.Are the Expresses and Extremes basically interchangeable for these purposes (other than antenna size and number of LAN ports)? I.e., any reason I can't use an Express as the "master" like I've described above?.Um, how do I actually configure this? All of the instructions I've found either reference a "wizard" (e.g., Roaming Network with Extreme and Express) or show screenshots that look very different from my Airport Utility (e.g., Wi-Fi base stations: Setting up and configuring a roaming network (802.11 a/b/g/n) - Apple Support).I've got a couple questions about this that I'd really appreciate advice on: As an outcome I'm hoping to have a single network (or two, see below) with a single password, so that devices can automatically connect to the strongest signal.Connect a mixture of Airport Extremes and Airport Expresses to the other ends of these wires (using their WAN ports).Connect the LAN port of the express to an ethernet switch, with wires running to the places where the wireless base stations will be placed (as well as to a few wired ethernet jacks).It's basically just playing the role of a NAT box, and, I guess, the "master"/"primary" creator of the wireless network.) ![]() ![]() (The express is small and can easily fit next to the modem in the basement. Connect an Airport express to the incoming line (cable modem), connected to the WAN port on the Express.though I'm open to using more if it would improve coverage. I would like to use a "roaming" configuration that takes advantage of existing ethernet wiring rather than just relaying wireless signals, and I'd like to use 3 or 4 base stations (different floors/areas of a house). I'm trying to set up a wireless network using airport extreme and airport express base stations.
0 Comments
Leave a Reply. |